Microjig GRR-RIPPER GR-100+ 3D Table Saw Pushblock 2-Pack

The Microjig® GRR-Ripper 3D Pushblock System will forever change the operation of a table saw. You will gain the confidence to comfortably make ultra-thin cuts with surgical precision and the control needed to make the exact cut you want. No other pushblock offers this level of accuracy, control, and safety. The GRR-Ripper was built for the table saw; however, its use around the workshop is endless. The GR-100+'s powerful grip controls stock and protects your hands from dangerous spinning bits on the router table, provides the traction needed to properly flatten stock for face-jointing on the jointer, and applies even pressure against the fence on your bandsaw, lessening blade drift and resulting in smoother cuts. Kickback occurs when the workpiece strays from the fence and gets pinched between the saw blade and the fence. The rear teeth of the blade grab the workpiece, turning it into a dangerous projectile. The only way to avoid kickback is to maintain control of your workpiece through the entire cut. The GRR-Ripper provides downward and inward pressure, keeping both sides of the cut parallel to the blade. This pressure prevents the workpiece from straying from the rip fence, virtually eliminating kickback. The new SafeRip Kit prevents the GRR-Ripper's center leg from being cut at the table saw. The SafeRip cursor and scales eliminate the need for leaning over to check the cut settings, allowing for quicker setup with no check passes.