On plush or textured carpet, you’ll usually get the best hold from:

• Non-skid rubber wedges: Look for a deep tread or textured base designed for carpet. Position the wedge near the hinge side for better leverage.
• Kickdown door stops: These mount to the lower edge of the door and use a rubber foot to hold the door in place. They’re handy when you want hands-free set-and-release control.

Wall- or hinge-mounted stops are great for limiting swing and protecting walls, but they typically don’t hold a door open. Consider the door’s weight and traffic level, and test placement to find the most stable spot. You can browse multiple styles and finishes online with pickup or delivery options.

Both protect walls, but they work a bit differently:

• Hinge pin stops: Install at the door’s top hinge to control how far the door opens. They’re adjustable, don’t require drilling into walls or trim, and help prevent the knob from striking the wall.
• Spring stops: Screw into the baseboard or wall and flex on impact. They absorb bumps, are low-profile, and are easy to replace if the tip wears out.

If you need to hold a door open, consider a wedge or kickdown style instead. Match the finish to your existing hardware and confirm clearance with your baseboard or trim profile. Installation can be straightforward, but following the product’s instructions typically yields the best results.

Swapping worn tips can be quick and can restore protection:

1. Measure the fit: Check the inner diameter of the old tip and the stem it fits on (spring, screw-in, or hinge-pin bumper) to choose a snug replacement.
2. Remove the old tip: Twist or pull it off. For screw-in bumpers, you may need to unthread the old pad.
3. Clean the area: Wipe away dust or paint so the new tip seats well.
4. Install the new tip: Press-fit or screw it on gently until secure—avoid over-tightening.

Rubber and silicone tips both help absorb impact; pick a color that blends with your hardware. Test the door slowly to confirm the tip contacts where you want.

Placement depends on the style and your door’s swing:

• Baseboard or wall-mounted stops: Mount low on the baseboard or wall so the stop touches the door before the knob hits. Open the door slowly to find the contact point, then mark and mount.
• Door-mounted stops: Attach to the door so it meets a wall plate or bumper at the right spot.

Check that the stop’s length allows contact where intended, and use anchors if you’re not mounting into wood. Predrilling can help prevent splitting. For adjustable hinge pin models, you’ll set the opening angle at the hinge instead of drilling the wall. Following the included instructions typically results in the most reliable placement.

Self-adhesive stops can work well when installed on the right surface:

• Prep the area: Clean, dry, and smooth surfaces (like painted drywall or tile) usually provide better adhesion. Avoid dust and texture where possible.
• Apply and wait: Press firmly and allow the adhesive to cure as directed before regular use.
• Match the job: For very heavy doors, high-traffic areas, or uneven surfaces, a screw-in or hinge-mounted option may offer more consistent performance.

Adhesive performance can vary with paint types, humidity, and surface condition. If you need repositioning later, remove carefully to help reduce finish damage. You’ll find both stick-on and screw-in styles available for pickup or delivery.