These RCBS factory replacement decapping units are the same ones we ship with our products — so you can rest assured they will work.
These replacement decapping units feature an expander rod, expander ball, and decapping pin. They are used in sizing dies to de-prime the case and expand the case neck in bottleneck cartridges. It is always a good idea to keep an extra decapping unit on-hand so you can ensure your reloading sessions do not get interrupted if you ever damage them during use.
- Factory Replacement Part
- Precision Machined to ensure concentricity
- Expander Rod, Expander Ball and Decapping Pin
- Limited Lifetime Warranty
Installation Instructions:
- Install the decap unit in the following manner:
Screw the decap unit into the die with 3/16" of the pin sticking out from the die. - With the decap unit hanging loose, lube a case and run it up into the size die.
- While the case is still in the size die, lock the nut down.
- Extract the case from the die and the die from the press. Check to see if the decap unit is centered by rotating the die in the large lock nut.
- If it is not centered, repeat the process, break the locknut loose, and size a case, turning the lock nut over before locking it down.
Compatibility
Can't find your cartridge, or not sure which decap unit or pin you need? Look it up here!
| 9827 | 9828 | 9829 | 9832 |
| Exp-Decap Unit .416 Taper | Exp-Decap Unit .338 Taper | Exp-Decap Unit 6mm Taper | Exp-Decap Unit .30 Taper |
| .416 Remington Magnum | .338-06/.338-06 A-Square | 6mm x 45 | 7.5mm x 54 French MAS |
| .416 Ruger | .338 Federal | | |
| | .338 RCM | | |
| 9833 | 9823 | 9824 |
| Exp-Decap Unit .270 Taper | Exp-Decap Unit .35 Whelen | Exp-Decap Unit 6.5mm T/CU |
| no available RCBS die | .35 Whelen | no available RCBS die |
| | .358 Winchester | |