Introduction:
This machine adopts pneumatic principle and is suitable for small-scale slotting and sampling. It is equipped with a digital moving caliper, which can quickly adjust the groove distance, cut the angle after slotting, and form quickly. It also has a new straight knife function (cutting cardboard), and the slotting degree of the blade head can be adjusted, which can open 70-160°.
Product Parameters
Drive Type: Electric-pneumatic integrated operation
Max. Slotting Stroke: 670 mm (26.4 in)
Applicable Materials: Cardstock, MDF, grey board
Slotting Thickness Range: 1–5 mm (0.04–0.2 in)
Slotting Angles: 90°, 120°, 145°
Voltage: 220V
Air Pressure: 0.6 MPa (87 psi)
Power: 75W
Control: Equipped with foot pedal
Precautions
1. Please note: An air compressor is required and must be supplied by the customer. Additionally, two 1.5V batteries (AA/LR6) are needed for operation.
2. Before starting operation, carefully check that the blades and fastening screws are securely tightened. If any looseness is found, tighten them immediately.
3. During operation, safety goggles must be worn at all times to protect against flying debris and particles.
4. Before feeding material for slotting, confirm that the pneumatic device is engaged and the workpiece is securely clamped. Keep hands away from the blade area at all times.
5. Cleaning, lubrication, and blade replacement must only be performed after the power supply has been completely disconnected.
6. Keep the blade area clear of debris to maintain cutting accuracy and prevent interference with operation.
Operating Instructions
Sample making begins
1. Firstly, place the sample paper at the desired distance (Figure 4-1)
2. Press the foot pedal, and the cardboard will press down on the paper to fix it (Figure 4-2)
3. Cut and sample the blade from right to right (Figure 4-3)
4. Four sided sampling completed (Figure 4-4)
5. After completing the four sided sampling, it is necessary to cut the corners on the sides
6. First, cut off a corner (Figure 4-5)
7. Step on the pneumatic foot switch for corner cutting and position the paper on both sides against the blade (Figure 4-6)
8. Place the left and right baffles against the cardboard and tighten the screws. (Figure 4-7)
9. Cut the cardboard in the opposite direction (Figure 4-7)
10. Cutting completed (Figure 4-8)
11. Calibration of digital scale: Place the cardboard against the rear side panel, open a dimension at will, and use a caliper to measure. If you need to open 500mm but the size of the cardboard is 400mm, you need to pull the 100mm scale back. Otherwise, the opposite is true (positioning completed)
Item Included (148067)
220V Pneumatic Sampling Machine *1