Planet Audio MB2200.5D Mini Bang Series 2200w 5 Channel Car Audio Amplifier Amp

Description:

Planet Pro MODEL 2200W High Output 5 Channel Full Range Class D Amplifier

Features:

• 2 Ohm Stable: The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.
  
  
• Class D Amps: Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. We use Class D in our Monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass.
  
  
• High and Low Level Inputs: An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.
  
  
• Protection: If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.
  
  
• Subwoofer Level Control: The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output.
  
  
• Switchable Input Sensitivity: Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.
  
  
• Variable Bass Boost: Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.
  
  
• Variable Gain Control: Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping.
  
  
• Variable High Pass Filter: Variable high-pass filter gives you control over the frequencies that pass through to the full range speakers.

• Variable Low Pass Filter: Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

Specifications:

• MODEL 2200W High Output 5 Channel Amplifier
  
• Up to 225 W X 4 RMS @ 2 ohm
  
• Up to 113 W X 4 RMS @ 4 ohm
  
• Up to 450 W X 2 RMS Bridged @ 4 ohm
  
• Up to 750 W X 1 RM