American Standard Cadet Ever Clean 72 in. x 42 in. Acrylic Whirlpool Tub in White

I have had this for several years, and no big problems as of yet (I hope I did not jinx myself). I am online today because the rotary dial tub stopper has always been a bit lacking - not lifting high enough, especially with the weight of water on it, so today I took it apart, adjusted the pivot hole setting and reinstalled. I was glad to find this serviceable from the topside-although I do not like it's design. I started hearing sounds like a bearing in the pump motor almost immediately - and routinely spray the shaft with WD40 - still not sure if it is a bearing sound, although the spray does quiet it - so that is worrisome. I bought the tile bead kit - but forgot to install it when I dropped the tub in (dummy), and bought the heater, but I have not installed it. I used a whole house Rheem 9.8 GPM tankless hot water heater dedicated to this tub, so I have more than enough HOT water. I just drain and refill a bit to keep it hot. Someday I may install the heater - I ran the electric -- I just haven't needed it yet. This model only has 8 jets, so you can not really get a message on specific areas, but it does make a tub of churning water. As another reviewer mentioned - the jets tend to spray all over if you are not careful to keep you body on them like a shield.

We've had this for a few months now. One of the jets was leaking within a couple weeks. Several service calls later, it appears to be fixed finally. The slant at the back of the tub is too much of an angle and when you lay back with the jets on, water sprays up your back and onto everything behind you.