Bolt-On Radius Rod Frame Bracket
Bolt-On Radius Rod Frame Bracket
Hero image 0 of Bolt-On Radius Rod Frame Bracket, 0 of 2
Speedway Motors

Bolt-On Radius Rod Frame Bracket

4.8 stars out of 29 reviews
(4.8)|
29 ratings
Car
Check if this fits your vehicle

Key item features

  • Bolts to the side of '28-up Ford frame rails
  • Extends further down for cars with spring-over axles
  • Great for moderately dropped front suspensions
  • Use with 11/16" tie rods ends (7 degree taper)
  • Premium steel plate construction is 1/4" thick
Current price is $57.99
Price when purchased online
  • Free 60-day returns

How do you want your item?

How do you want your item?
Columbus, 43215
Arrives by Mon, Mar 9
|
Shipping fee $13.99
Sold and shipped by Speedway Motors, INC
4.482035928143713 stars out of 5, based on 334 seller reviews(4.5)
Report an issue with this seller
Free 60-day returns

About this item

Product details

Specifications

Warranty

Warnings

Customer ratings & reviews

4.8 out of 5 stars
stars29 ratings29 reviews
How item rating is calculated
  1. 5 stars86% (25)
  2. 4 stars7% (2)
  3. 3 stars7% (2)
  4. 2 stars0% (0)
  5. 1 star0% (0)
Filtered and sorted results would be available on the new 'Customer ratings & reviews' page.
Sort by |

Showing 1-3 of 29 reviews

Aug 27, 2010
Hot Rod Scott
5 out of 5 stars review

So good I've used them twice!

No fabrication required to have strong, attractive mounts on your hot rod. Just bolt (or weld) on and your in business! They're so good I've used then on two cars so far. And yes, I will use this product on future builds. The only setback is you must drill the taper out to use heim joints but any rodder can handle that! Thanks for a great product I can put confidence in!

Review from speedwaymotors.com
Helpful?5GWWVXSFHLXF746657230
Apr 6, 2016
El Guapo
5 out of 5 stars review

Good and simple

These are good, simple pieces for those looking for some old school flavor. They are remarkably similar to the ones that I cut off my A-bone (built in the mid fifties) when I started stripping it. The holes are just enough oversize to allow about .015"" wiggle for fine tuning the alignment. I would have preferred a bare/bead blasted finish as it would have saved me the step of stripping them to ensure that there weren't any compatibility issues with my finish.

Review from speedwaymotors.com
Helpful?5GWWVXSFHLXF746657230
Jun 25, 2012
King B
5 out of 5 stars review

did the job!!

had to drill out to fit 5/8"" bolt....they are made to fit tapered rod end....it would be nice to offer 3/4"" straight hole and then give spacers for taper or a reducer to use 5/8 or maybe 1/2""

Review from speedwaymotors.com
Helpful?5GWWVXSFHLXF746657230