Descriptions
The charging prompt during charging is very intuitive, and when the battery is fully charged, it will stop charging, and the `Standby indicator` on the panel will light up.
All GPIOs is leading out and providing clear silkscreens which are very convenient for Pico experiments.
It is plug-and-play module.
This device is a power supply device, please pay attention to the positive and negative poles of the battery. Reverse battery connection may damage your UPS device or Pico development board.Please check the circuit carefully before turning on the power switch to avoid equipment damage caused by short circuit.
Features
Plug & Play
Support Raspberry Pi Pico Only
Monitor battery voltage (error ±2%), monitor battery current (error ±10%).
Monitor the charging current.
If it is not in charging mode, the power LED indicator will not be on, wake up for 5 seconds every 2 minutes to reduce light pollution.
In charging mode, it can judge whether it is fully charged, and stop flashing lights when fully charged.
In charging mode, the LED will flash when it is not fully charged.
Evenly allocate the power ratio of each LED to prevent the load from appearing abruptly.
The static power consumption is less than 10mA.
Serial output data.
Only supports 18650 lithium battery
Note: It is normal that the current consumption can still be read when the PICO is not connected and the power switch is turned on. After all, the board also consumes a small amount of electricity, which can be ignored. MicroUSB port on UPS which marked 'USB_IN' is only for charging, DO NOT Connect it to USB Port on laptop or PC!!!
Package includes:1 x UPS for Raspberry Pi Pico / Pico W,1 x instruction（Raspberry Pi Pico NOT Included）
