Rug grippers can help reduce sliding and corner curl on many hard floors, but performance depends on your setup.

• Floor & rug type: Smooth hardwood, tile, and laminate typically need more grip than textured surfaces. Thin, flat-weave rugs usually benefit quickly.
• Style match: Corner/edge stickers help with curl, while full-size pads offer broader hold and cushioning for larger rugs.
• Prep & placement: Clean and dry floors and rug backs before applying. Position grippers near edges and high‑traffic areas.

Using the right size and type for your floor can noticeably cut movement, though results vary with traffic and rug weight. If you’re unsure, start with a small pack and adjust placement.

Several under‑rug options can help minimize sliding, depending on your space:

• Non‑slip rug pads: Full‑surface pads add grip and cushioning under area rugs and runners. Choose low‑profile for doors.
• Corner or edge grippers: Small, thin pieces that target curl and slip at the perimeter.
• Rug tape/strips: Double‑sided, low‑tack strips for temporary hold; best on clean, sealed hard floors.
• Open‑weave pads: Breathable grip for small rugs and bath areas where airflow matters.

Measure your rug and select a pad slightly smaller than the rug outline for a clean edge. On Walmart.com, you can filter by size and floor type to find a good fit.

On sealed hardwood, many shoppers prefer pads designed specifically for hard floors.

• Combo felt + rubber pads: Felt adds cushion; the rubber side faces the floor for grip—useful under medium to large rugs.
• Low‑profile rubber pads: Thin, grippy pads for doors or thin flat‑weave rugs.
• Avoid aggressive adhesives: High‑tack tapes may leave residue on some finishes; test any adhesive in a low‑visibility spot.
• Keep surfaces clean: Dust can act like ball bearings; a quick sweep or vacuum helps grip.

Always check product descriptions for hardwood compatibility and follow your flooring care guidelines. If your floors were recently finished, waiting the manufacturer’s recommended cure time before using grippers is a good precaution.

For a rug on top of carpet, look for solutions made for “carpet‑to‑carpet” grip.

• Carpet‑to‑carpet pads: Underlays designed to anchor a rug to carpet without sticky adhesives.
• Textured underlays: Fiber or hook‑like textures help grab carpet pile and resist creep.
• Size and placement: Use a pad slightly smaller than the rug, centered to support the whole area—not just the corners.
• Maintenance: Regularly vacuum both layers to reduce lint and slip.

These options can reduce shifting without damaging the carpet. Check listings for “safe for carpet” notes and choose a low‑profile pad to minimize edge lift in walkways.

Thoughtful setup can help protect your floors while adding grip.

• Match to your floor: Choose products labeled for your surface (hardwood, tile, laminate, or carpet). When in doubt, opt for non‑adhesive pads.
• Prep first: Clean and dry the floor and rug back. Avoid use on freshly finished or waxed floors until fully cured per the flooring maker.
• Test & remove carefully: Test any adhesive in a small spot. To remove, lift slowly at a low angle; roll up residue rather than scraping.
• Rotate & replace: Periodically lift the rug, clean underneath, and replace grippers if they lose tack.

Product pages often note compatibility and care tips, which can help you choose safely.