Great question—fit and stability matter. A 65-inch TV is roughly 57 inches wide, so a console that’s a bit wider helps with balance and style.

• Width: Look for a media console around 60–70 inches wide, or any model listed as “for TVs up to 65 inches” (or larger).
• Weight capacity: Compare the TV’s weight to the cabinet’s stated limit on the product page.
• Height: Many prefer the TV’s center near seated eye level (about 40–43 inches). Choose a cabinet height that gets you close.
• Depth & ventilation: Leave space behind for plugs and airflow.
• Safety: Consider using the included anti-tip kit or a wall anchor.

Always confirm exact specs on the individual product page.

A quick measure-up can help you pick the right console cabinet and avoid tight squeezes.

1. Wall width: Measure the available wall section and leave a few inches of breathing room on each side.
2. Depth: Compare cabinet depth to your space; make sure doors and drawers can open without hitting trim or furniture.
3. Walkways: Keep 24–36 inches of clear path in high-traffic areas.
4. Height: For TV use, aim for comfortable viewing; for sideboards, check that serving height feels right.
5. Power & media: Note outlet locations and plan for cable routing.
6. Delivery path: Measure doorways, hallways, and stairs to ensure it can be brought in.

Compare your measurements with the dimensions listed on the product page.

Most console cabinets and media consoles arrive flat-packed with labeled parts and hardware.

• Tools: A Phillips screwdriver is commonly needed; a rubber mallet and level can be helpful. A drill may assist with pilot holes if recommended by the instructions.
• Time: Assembly can range from about 60–120 minutes, depending on size and your experience.
• Setup tips: Lay parts on a soft surface, sort hardware, and follow the steps in order. Avoid overtightening to protect finishes.
• Safety: Two people make larger units easier to build and move. Use any included anti-tip straps.
• Need help: If parts are missing or damaged, use your Walmart order details to contact the seller or customer care.

Neat cable routing can make your setup look cleaner and help airflow.

• Use built-ins: Many media consoles include rear cutouts. Feed power and signal cables through these openings.
• Bundle smartly: Velcro ties or reusable straps can group cables without pinching them.
• Cable path: Keep power cords separate from signal lines where possible to reduce interference.
• Surge protection: A surge protector with a slim profile can sit on a shelf; check shelf depth before choosing.
• Stick-on guides: Adhesive clips and raceways route wires along the back discreetly.
• No drilling: If additional holes seem helpful, consult the product instructions first to avoid damage.

Gentle care keeps console cabinets looking fresh without risking the finish.

• General dusting: Use a soft, dry microfiber cloth on all surfaces.
• Wood finishes: Wipe with a slightly damp cloth and mild soap if needed, then dry immediately. Avoid abrasives and harsh chemicals.
• Glass doors: Apply glass cleaner to a cloth (not directly on the surface) to prevent drips into frames.
• Fluted details/rattan: Use a soft brush attachment on a vacuum or a clean, soft brush to lift dust from grooves and weave.
• Protective habits: Use coasters, placemats, and felt pads under decor to reduce scratches and water rings.
• Spot test: Try any cleaner on a hidden area first.