Permatex 5 Minute Gap Filling Epoxy is a versatile, easy-to-use, general purpose two-part adhesive and filler system. Sets in five minutes with no clamping needed. This clear epoxy fills gaps and will not shrink. Resistant to water and solvents with a permanent strength up to 3400 PSI. Temperature range -60°F to 180°F (-51°C to 82°C).

• Fast-setting, clear epoxy in an easy-to-use 2-part dispensing syringe; permanent strength up to 3400 PSI
• This water and solvent resistant epoxy sets in 5 minutes with no clamping needed
• Better choice than super glues for bonding parts with larger gaps; fills gaps and will not shrink
• Temperature Range: -60°F to 180°F (-51°C to 82°C)
• Suggested Applications: Complex, multi-piece assemblies. Bonds rigid materials including ceramic, chrome, fabric, fiberglass, glass, hard plastic, metal and rubber

Permatex 5 Minute Gap Filling Epoxy is a versatile, easy-to-use, general purpose epoxy adhesive that is ideal for complex, multi-piece assemblies and bonding rigid materials. It is a two-part adhesive and filler system that sets in five minutes. This clear epoxy fills gaps and will not shrink. Resistant to water and solvents. Permanent strength up to 3400 PSI.

DIRECTIONS:

1. PROTECT: Work area must be protected from accidental spills.
2. CLEAN: Surfaces must be clean, dry and free of grease and oil.
3. PREPARE: Roughen smooth surfaces (using abrasives or sandpaper).
4. OPEN PACKAGE: Remove syringe. Using a sharp blade, cut off tips of both nozzles.
5. DISPENSE: Depress plunger to dispense resin and hardener. Thoroughly mix resin & hardener on a clean, discardable surface for 2 to 3 minutes until evenly colored.
6. APPLICATION: Apply a small amount of mixture to both surfaces and assemble parts immediately (product sets in 4-6 minutes).Remove any excess epoxy immediately.
7. CURE TIME: Usable strength is reached in four hours at72°F (22°C). Cooler temperatures may require longer set time.
8. CLEAN-UP: Attach nozzle cap and store in molded tray.

NOTE: Adhesive will not bond most polyethylene or polypropylene plastics.