Slevoo Baby Jumper, Baby Doorway Jumper Bouncer with Bumper & Play Tray

Installation Requirements:
Indoor use only – Designed for interior doors with:
Door height ≤7 inches
Wall thickness 4-12 inches
Sturdy door molding securely attached to wall
Flat top surface ≥½ inch wide

Installation Guide
Step 1: Secure Door Setup
Center the clamps on the door’s flat top surface.
Verify the door frame is sturdy and undamaged to safely support your child’s weight.

Step 2: Height Adjustment
Use the adjustment straps to set the jumper height so your baby’s toes lightly brush the floor.
Re-adjust monthly as they grow—proper positioning supports healthy hip development.

Step 3: Frame Assembly & Placement
Snap the frame tubes into place until fully locked.
Position baby with arms through the fabric sides. For smaller infants, add soft fabric inserts around the torso for a snug, safe fit.

Step 4: Safety Check
Double-check foot positioning before use: toes should gently touch the floor, heels raised naturally.
Never leave unattended—always supervise bouncing sessions.

Safety Note: Please read the instruction manual carefully before use. Please measure the dimensions of your door frame and its molding first to make sure the baby jumper is compatible with your doorway. Only use for 80" to 87" high door frame, and wall thickness between 4 - 12 inch (10 - 30cm) and with a trim thickness of at least 0.5 inch (13 mm). Not suitable for round and glass door cover load-bearing beam to prevent the jumper from slipping.