eXtremeRate White 6 Profiles & Back Shell & Side Rails & 4 Back Buttons for Xbox Core Controller

NOTICE:
ONLY fits for Xbox Series X & S controller (Xbox Core controller Model 1914); Not compatible with other model controllers and other 3rd parties charging station.
You need to take apart your controller for installation, soldering and high hands-on skills are required.
Compatible with eXtremeRate Clicky Kit, FLEXOR side rails, DTF LED Kit for Xbox Series X/S controller.
Installation Tips:
Installation difficulty: high
Patience needed: high
Please view the installation video carefully before installation.
Get the installation video guide on YouTube by searching eXtremeRate Victor X Remap Kit for Xbox Series X/S Controller".
If you have any problems during the installation process, please feel free to send us a message.
The FPC board needs to be soldered and the FPC board should be fixed with double-sided tape before soldering.
Please note that if you have installed eXtremeRate HOPE remap kit, and want to turn it to Victor X remap kit, then you don't need to solder again.
When soldering, please be careful not to pull the FPC cable, the soldering time of each TP point is less than 1 second.
After soldering, it can be tested with the test board.
If all the LEDs on the tester board are not lit, please check P2 and TP35 solder points whether soldering correctly.
If only some of the LEDs are not lit, please check the corresponding solder points on the FPC cable to see whether soldering correctly, if not, fix them.
Double-click the setting button to swift the profile you want to use or configure.
Press and hold the setting button for 3 seconds, the light will flash, then enter buttons programming mode; press and hold the setting button for 3 seconds again the light will stay and exit the setting mode.
You can activate the remapping program during the game and assign a maximum of 14 buttons (A, B, X, Y, L3, R3, LT, RT, LB, RB, Up, Down, Left and Right ) to the back buttons.