X10 PRO 16-Channel Wireless Base Transceiver Module (PAT03)

Add wireless control to your X10 devices, plus amplify X10 powerline signals with the X10 PRO 16-Channel Wireless Base Transceiver Module. Designed as an upgraded replacement for the old PAT01 transceiver model (discontinued), this new PAT03 model offers improved signal amplification (10 times more powerful) as well as built-in AGC (Automatic Gain Control). AGC helps reduce noise in the direct vicinity of the transceiver, making your entire X10 network more reliable. FEATURES: Converts RF signals into X10 commands. Amplifies X10 signals 10 times more than older model. Built-in appliance module. Controls up to 16 X10 receivers. Sends status reports over the powerline. Warranty: 2 years. How It Works: The PAT03 transceiver module picks up radio frequency (RF) signals from X10 wireless remotes and then converts those signals into X10 commands, which are sent over your powerlines. The transceiver also provides a built-in appliance module, which responds to Unit Codes 1 through 9. Plug an appliance or light into the module's outlet to enable wireless X10 control for that load. X10 Transceivers Compared: As two-way transceivers, the PAT03 and RR501 transceiver models (RR501 sold separately) offer advanced features over the TM751 transceiver model (sold separately). The TM751's built-in appliance module can be controlled by RF signals only. In contrast, this PAT03 model receives both RF signals and X10 powerline signals, allowing you to control the built-in module either wirelessly or over the powerline, and to receive status reports over the powerline. NOTES: 1) This revamped PAT03 model serves as a replacement for the discontinued PAT01 model. 2) Built-in outlet does not support dimming. 3) Use only one RF Base Transceiver Module or X10 Security Console (which also converts RF signals into X10 signals) per House Code. If more than one transceiver is used on the same House Code, X10 signal collisions may result.