Sliick Gummy Bear Hard Wax Beads, at Home Waxing, For Face and Body, 8 oz

Ingredients

HEATING INSTRUCTIONS: Pro Wax Warmer: 1. Slide reusable silicone wax shield up and around removable wax pot. Replace in warmer. 2. Pour desired amount of Hard Wax Beads into removable wax pot. 3. Set temperature to High (125°C) for 30-40 minutes until wax has a thick/caramel-like consistency, then set the temperature to Medium (80°C) for the rest of application time. NOTE: Heating times and settings vary based on the amount of wax that is being heated. Microwave Melting Cup: 1. Pour desired amount of Hard Wax Beads into microwave melting cup. 2. Place cup in center of microwave. Heat for 45 second increments until wax has a thick/caramel-like consistency. 3. Carefully remove melting cup from the microwave by using the reinforced handle. APPLICATION INSTRUCTIONS: 1. Test wax temperature on the inside of your wrist before application. 2. Clean area to remove excess oil, makeup or lotions. Pat dry. 3. For best results, hair should be at least 1/4” long. 4. Holding the silicone applicator at a 45° angle, apply a thick layer of wax in the direction of hair growth (if using near the eye area keep eyes closed). 5. Allow wax to cool on the skin until it becomes soft and pliable, approximately 1-2 minutes. 6. Hold the skin taut and pull wax off (parallel to the skin) with one quick motion in the opposite direction of hair growth. 7. Immediately apply firm pressure to epilated area with the cushion of your finger or palm of your hand to calm the skin. 8. Apply Sliick Soothe Post Wax Lavender Oil to the skin to soothe, condition and remove excess wax.