Fabricate cabinets square, rigid and without warp, with metal faces flat and free from dents or distortion- Make all exposed metal edges safe to touch- Weld frame members together to form rigid, one-piece structure- Weld, bolt, or rivet other joints and connections as standard with manufacturer- Grind exposed welds flush- Do not expose bolts or rivet heads on fronts of cabinet doors or frames-FeaturesNo bolt heads show on front or on side panelsPositive three point locking (top, center and bottom) and theft resistant hinges for securityShelves easily adjust up or down in 2 in- incrementsTripleflanged shelf front for added strengthDoors swing out quietly a full 180' and are 'HAT' section reinforcedCorner foot gussets provide added rigidity and stability22 Gauge body22 Gauge Shelves adjust on 2 in- center22 Gauge door with 16 Gauge frame16 Gauge continuous piano hinge200 lb shelf capacityDoors include key lock and 3-point turn handleAll cabinet parts to be cleaned and coated after fabrication with a seven stage zinc/iron phosphate solution to inhibit corrosion, followed by a coat of high grade custom blend powder electrostatically sprayed and baked at 350 degrees Fahrenheit for a minimum of 20 minutes to provide a tough durable finish-FrameFabricate of 16 gauge (minimum) channels, with integral continuous door stop/strike formed on both latch and hinge side vertical members- Cross frame members of 16 gauge channel shapes shall be securely welded to the vertical framing members to ensure rigidity- Bottom frame member to be not less than 4 in- high-DoorsFabricate back and sides of 22 gauge (minimum) sheet steel- Sides to include a single bend at the vertical edges which overlap the offset of the vertical edge on the rear panel- Adjustable shelf retainer strips are to be spot welded to the inner side panels allowing shelf adjustment on 2 in- centers- Form top and bottom of 22 gauge (minimum) sheet steel bolted at all four sides-EquipmentForm shelves of 22 gauge (minimum) sheet steel with single bends at sides and double return bends at both the front and back- Shelves are adjustable on 2 in- centers-Center PartitionProvide not less than two coat hooks located below the coat rod on the wardrobe side ofthe combination cabinet- SKU: 000GRP-HLWL4111
