Zimtown DIY 20-Cube Wire Grid Storage Organizer, 14"x14" Modular Wardrobe Bookshelf for Office Bedroom Bathroom Living Room, Black

This is my second time purchasing this item. I bought the second set to expand upon the first set and was able to do so without any problems. I am very happy with the quality, strength, and durability.

I bought this twenty cube set to make several three bay top shelf closet organizers and a three high corner shelf. I am very satisfied with the results. NOTE:The wire squares are weak and bendable if overloaded! The include hammer is worthless; a rubber mallet or strong palm hit does the job. Alternately I pulled a couple of joints together in the back of the closet with channel lock pliers. A standard letter - legal file box will fit in the openings, but think light items. The limiting factor to building multiple units is the number of plastic corner pieces; I found a solution for this: black zip-ties. Three units require 43" of width, I fit one unit in 42" by selectively rotating the plastic corners so the flat side on the ends was perpendicular to the wall. For the top shelf in my closets: I made two ends using four top corners pieces each with the front and bottom open, I then zip-tied a shelf in at half height with four zip-ties being sure to get back, side, and shelf fastened together, I placed these two units on the closet shelf then attached two wire squares between them using the existing top corners, and a half height shelf zip-tied between them, the center section uses just two wire pieces. This shelf unit used just 8 corners, 12 wire squares, and 12 zip-ties. Leaving off the 8 bottom corners is key to creating more units. If your closet is narrower than 42" you can overlap the center top wire square and just zip tie it in place and no mid shelf without cutting a square down. The squares have a flush side and a depressed side so I took care to make the flush side up everywhere. So far I have made three horizontal three bay units using 8 corners [12 squares] each and one vertical three stack using 16 corners [14 squares, one bay has a half height shelf]; 40 of the 64 included corners are used, so I can build two more closet units as above or use the remaining 24 corners and 31 squares to built whatever.