Vinyl Air Tint Wrap Film Protection Roll 12x47 Inch for Car Headlight Taillight Fog Light Sider Marker Light Transparent

Vinyl Air Tint Wrap Film Protection Roll 12x47 Inch for Car Headlight Taillight Fog Light Sider Marker Light Transparent
Vinyl tint wrap is designed to fit and stretch around difficult surfaces. Universal for most car headlight taillight fog light sider marker lights. It is scratch, grime, water and dirt resistant. Very easy to use. When you remove it, it won't damage your lights and won't leave any residue behind. Layers: 3 Layers. From inside to outside: Application Side Protective layer, Vinyl Tint Wrap, Wrap Outer Protective layer. Installation instructions: Cut: Cut it according to your light and allow 5cm larger. Clean: Clean the surface of your light with a towel. Paste: Take off the inner protective layer corner and start from a small area, then stretch to cover a larger area. You may add a little water as well. Use a squeegee to smooth and remove air. For Curved Surface: Use a drier to heat it then stretch. Also, use the squeegee to help. Finish: Use a small tool to cut the useless area along the light edge. To Take Off: Please remember to turn off the light and wait until it's at a moderate temperature, not too cold or too hot.