Aluminum Case Resistor 10W 2.2 Ohm Green Wirewound for Rod Post 10W2.2RJ

Aluminum Housed. An insulated cover on the wounded wires would block out the heat, which promises the high performance of a resistor. Hence, the cooling job was achieved by aluminum case.
This 10W resistor formed with qualified copper, nickel, and aluminum. With the compact structure and heat dissipation design, a capability of overload has been built.
Board length 3/4 inches(19mm) and two rods with 1.8mm hole for a soldering connection. Dia. 2.5mm antisymmetric anchoring hole for holding, which will fit #2 Screws(or M2.3 nuts)
Reliable. Problems like the flush would have a perfect solution, or you can use it in any DC circuits, converter, inverter, motor speed control, drivers, etc.

Main Body Length: 1.9 cm/ 0.75 inches
Power: 10 Wattage
Rated Resistance: 2.2 R
Tolerances: 5%(J)
Connection Type: Rod terminals with hole
Rod Length: 7.7mm/0.3 inches
Screw Hole: 2.5mm(Fit #2 or M2.3 nuts)
Distance between screw hole: 14mm
Weight: 6g/0.15 Oz
Materials: Nickel alloys Wire Wound Resistor with Aluminum Case
Color: Gold
 
Package Content:
1 x 1