Disc Brake Rotor and Bearing-Seal Kit, 5 on 4-1/2 Inch, Fits Mustang II

A fresh rebuild will help you roll down the road the way you intended! Our tech experts here at Speedway Motors found that sometimes you just need a good old fashioned rebuild kit with fresh wear parts. A kit of just bearings and rotors to replace those worn out braking components on your street rod or hot rod truck! Kit Contains: (2) Speedway Motors Mustang II Disc Brake Rotor. (1) Speedway Motors Bearing-Seal Kit. Speedway Motors Mustang II Disc Brake Rotor Vented stock 9-1/4" diameter brake rotors for 1974-1980 Mustang II, Pinto, or Bobcat spindles (or Speedway brake kits using '49-'54 Chevy spindles). These five lug conversion brake rotors are new, not plugged or re-drilled. Has a 5 on 4-1/2" bolt pattern with corresponding 1/2" diameter fine thread wheel studs. 5 on 4-1/2 Inch. Outside Diameter of rotor disc - 9.256" Thickness of vented disc - .884" I.D. of the back side of rotor - 6.256" Rear rotor face to bearing hub - .290" Outer hub diameter where wheel will mount - 5.834" Outer hub height - 1.450" Bearing snout is 1.60" tall, 2.55" diameter at bottom and 2.384" at outer end. Speedway Motors Bearing-Seal Kit This bearing and seal kit includes two inner wheel bearings, two outer wheel bearings, and two inner grease seals. This kit is enough for two brake rotors and is intended to be used with a new rotor installation as this bearing and seal kit kit does not include the bearing races or cups.   Bearing races or cups are provided as installed and included inside the new rotors as part of this rotor and new bearing and seal kit. Includes (2) inner wheel bearings, (2) outer wheel bearings, and (2) inner grease seals. Enough for two brake rotors. No races or cups included. -Large Bearing- Thickness: .656" Upper OD: 1.900" Lower OD: 2.150" Bearing ID: 1.375" -Small Bearing- Thickness: .651" Upper OD: 1.380" Lower OD: 1.570" Bearing ID: 0.864"