For cuts, strips and crimps 2 type of plugs in 1.
Manufacturer Part No: HT-568R
This medium duty crimp tool can be used for terminating a RJ45 plug with a stranded 4-pair unshielded twisted pair cable, making a patch cable assembly; it can also be used for terminating a RJ12 or RJ11 plug with a 3-pair or 2-pair unsheiled phone cable.
Instructions:
Non-ratchet Type: Remove the closed lock to open the handles.
Ratchet Type: Squeeze the handles until it stops to open the handles.
Cutting modular cable:
Place the single-bladed side of the tool's cutter facing you and cut the modular cable to the desired length. make sure to cut the ends of the cord straight across, not diagonally. Stripping modular cable (Flat Cable):
2a. Insert 4P/6P cable into the two-bladed side of the tool's stripper until it touches the stop guide.
2b. Insert 8P/10P cable insto the two-bladed side of the tool's stripper and let it extend a little past the lower cut blade. Squeeze handles until it stops, cable must be kept perpendicular and then pull from the tool. Stripping Round Cable
Inster the cable into the round stripping hole, turn the crimper in counter clockwise direction and cable in clockwise at the same time. Remove the outer jacket, insert the stripped cable into the plug and be sure the left wire at one end matches the right wire at the other end. Place modular plug with cable into the tool's holder. Be sure the stripped wire is between the tab and gold contacts. Squeeze handles until it stops. Remove the crimped plug from the tool. For stripping UTP/STP round cable, please HT-S501A for good result.
Pickup or delivery?