10" LOADED SUBWOOFER
Ported enclosure loaded with one 10" Subwoofer
3/4" medium-density fiberboard construction covered with carpet
4-ohm total impedance
power handling: 50-300 watts RMS (600W peak power)
Frequency response: 30-500 Hz
sensitivity: 93.8 dB
21-1/2"W x 15"H x 7-5/8"D1 x 4"D2
warranty: 1 year
Ported enclosure loaded with one 10" Subwoofer
4 Mounting brackets
Four 1" Self-tapping pan head screws
Eight 5/8" Self-tapping flat head screws
Specification and mounting information
AMPLIFIER
Prime Series Class D Monoblock Car Amplifier
Power Rating:
-300 watts RMS @ 4-ohms.
-500 watts RMS @ 2-ohms.
CEA-2006 compliant amplifier
MOSFET power supply.
Cast aluminum heatsink.
Muted turn on.
Short circuit protection.
Efficient Class-D circuit topology.
12dB/octave Butterworth crossover.
RCA pass-thru outputs.
On-board Punch EQ with +18dB boost @ 45Hz.
High level inputs.
Remote PLC (Punch Level Control)
0°/180° Phase Switch.
Real time output and power supply thermal sensing.
Over current protection.
Frequency Response: 20 - 250 Hz +/- 1 dB.
Efficiency: 89% @ 4-ohm.
Total Harmonic Distortion: <1.0%
Signal to Noise Ratio: >100 dB.
Damping Factor: >200 dB.
Input Sensitivity: 150 mV - 4V.
4 Gauge power/ground connectors.
8-gauge speaker wire terminals.
AMP KIT
20 ft. 8 GA Red Power Cable.
Competition High Quality Fuse Holder.
1/4" Ring Terminal.
3 ft. 8 GA Black Ground Cable #10 Ring Terminal.
16 ft. 18 GA Blue Turn-On Wire.
20 ft. High Performance RCA (TRCA) Interconnect (3) Rubber Grommets.
30 ft. Speaker Wire 5/16" Ring Terminal.
6 ft. Split Loom Tubing (20) 4" Wire Ties
