SE Metal Hole Punch Pliers with Gauge Guard - Precision Pliers for Crafts, Jewelry, DIY - Red - Size of 2.0 mm - 6-Inch - LF12-3PP

The SE LF12-3PP Red 6" Hole Punch Pliers with 2.0 mm Diameter punch a 2.0 mm hole in metal sheet stock up to 18 gauge and create a smooth, clean hole without barbs or rough edges. The hole punch is 2.0 mm in diameter and will go through 18 gauge wire or thinner. Included are two extra replacement tips so you can replace a worn tip with a new one. There are a total of 3 tips. Our pliers feature a gauge guard which keeps the area around the hole free of marks and the angled tip leaves a clean hole after punching.The rubber dipped handles gives an added comfort grip and reduces slip resistance. You can punch 2.0 mm round holes in copper, silver, or other soft metals up to 18 gauge thick. The pliers have an angled tip and includes a gauge. They are 6" long and 2-1/8" wide at the handle.How to use:Hold the pliers shut. When properly adjusted, there should be enough space to insert your metal piece between the widest part of the pin and the bottom jaw of the pliers with a little extra room left over. If the metal does not fit or if there is no extra space, simply expand the jaw opening a little farther by turning the gauge guard screw to the right.SE is committed to providing the customer with the best source for value possible on the market. You will enjoy the quality, function and usefulness of our SE LF12-3PP Red 6" Hole Punch Pliers with 2.0 mm Diameter.IPR Rights Notice:Important: Avoid getting counterfeit items. Genuine SE products come with the SE logo on the packaging.SE is a registered trademark protected by US Trademark Law.