4" 10000rpm Air Polisher Sander Grinder Water Jet Pneumatic Grinder Marble Stone 0.7KW

The air grinder is a mechanized hand tool powered by compressed air. It is suitable for surface polishing operations in the building decoration manufacturing industry. It can be cooled at the same time as the sanding operation and it provides efficient sanding results, saving you time and energy. This highly efficient and versatile product is ideal for professionals.

Specification

Shell Material: #45 Steel

Handle Material: Rubber

Color: Green

Power Source: Air

Max Grinder Size:100mm/4in

Power: 0.7KW

Air Consumption: 1.2m³/min(42CFM)

Air Pipe Inner Diameter:13mm/0.51in

Water Pipe Inner Diameter:8mm/0.31in

Air Inlet Size: 0.64cm/ 1/4"

Free Speed: 0 to 10000r/min

Assembly Required: Yes

Product Size(φ*L): 5.7*29cm/2.24*11.42in

Package Size: 30*13*8cm/11.81*5.12*3.15in

Gross Weight: 2.3kg/5.07lbs

Net Weight: 2kg/4.41lbs

Package Included

1*Air Grinder

2*Wrenches

All Accessories for Installation

Notes

The compressed air should be maintained at 0.49 0.63 MPa and purified. Excessive air pressure will cause the wear of the parts to increase and the linear speed of the grinding disc will exceed the allowable value. Air pressure is too low will make the tool output power significantly reduced.

The pipeline should be equipped with filters, pressure regulators, and lubricating oil. Lubricating oil must be injected from the air pipe 3-4 times a day. Normally, No. 10-20 mechanical oil can be used. Bearings are coated with No. 2 calcium-based grease twice a month. Before and after daily use, please inject 2~3 drops of pneumatic lubricant into the air inlet.

Before connecting the tool to the air circuit, please open the air circuit to expel the stolen goods into the air. The connection with this tool should be sealed and secured.

After connecting the tool to the gas path, the grinding disc should be rotated slowly to observe the condition of the grinding disc and the tool. If an abnormality is found, it should be closed in time. In normal use, the force should be moderated appropriately, the impact method should not be used for pregrinding.

When the tool breaks down, it is forbidden to disassemble it on the spot, and it should be sent to the repair department for overhaul in time. Please do not throw this tool around during work to avoid affecting performance and damaging parts.

Correct maintenance is very important to ensure the performance and service life of the machine, and the tools must be repaired and maintained regularly. The maintenance period depends on the degree of use. Under normal circumstances, maintenance should be carried out once a month. Parts should be cleaned and lubricated. Worn or damaged parts such as blades, rotors, the front and rear cover, cylinder body of the cylinder should be refurbished or replaced in time.

Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering.