6mm shank Solid Carbide Spiral 2 Flutes Ball Nose End Mill Cutter Engraving Bit

Description:

1. for the design of portable and desktop woodworking engraving

machine, can not be used in drill machine.

2. smooth surfaces, such as wood, to avoid the processing of copper,

iron and other metal and sand, stone and other non wood materials.

3. use appropriate size clip.

4. tool clamping, found that the cutter has a beating phenomenon, should

immediately stop, repeat clip a few times to get the tool shank and fixture

to get full contact, and then work.

5. cutter handle and the clamping sleeve contact should be good, a tool

shank must be fully inserted into the jacket, tighten firmly.

Specification:

Type:Spiral 2 Flutes Ball Nose

Shank:6mm

Material:steel

Color:silver

Size:as picture show

Non stick cutter, tasteless, quiet, blade design, sharp

Clean, tidy, no burr

Spiral chip design, chip smooth, reduce heat

Applies to the relief process of sub GREE, PVC, density board, hard wood

Quantity:1PC

Package included:

1 x Double edge milling cutter

Note:

1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.

2. Please allow slight manual measurement deviation for the data