Gorilla Glue Clear Epoxy Syringe, 0.85 Fluid Ounce, Clear Finish

Worked as intended to fix a broken plastic lid. Cleaned with alcohol first and held together overnight with duct tape. It seems like a sturdy hold so it worked.

This Gorilla Glue Clear Craft Epoxy is extremely tough and durable stuff but there are a few things that you may want to know.. It smells like rotten eggs It attains it's durability due to having a rubber-like consistency, although like extremely hard rubber but to the point a square inch cube of it won't crack or break under 3700psi of pressure. If you don't mix it close enough to 50/50 and mix it well enough in the short amount of time that you'll have then it won't harden and cure like you will expect. To combat this issue it helps to mix a larger amount of it so it will minimize any inconsistencies you may have when mixing the two parts together. It goes on a bit thick so spread it out quickly if you're trying to coat a surface evenly because when it does begin setting it will be too late to spread it so that it turns out nice, even, and clear; best to just leave it as is and just sand it down later. It's not fully cured if it still has a smell to it when holding it up to your nose, so don't coat it with anything until it no longer has that smell. Would likely be best to add an epoxy thinner to it when mixing it together so it has an easier consistency to properly mix more quickly, apply more smoothly, as well as create a stronger bond.