Features:
1. Rebar Tier is a hand held machine used to pack rebars quickly, It can save 3-5 times than man power by hand.
2. Used for building market, including civil building, floor pipe, heating floor mesh, steel bar, etc.
3. Reasonable structure, advanced craft, simple and convenient operation, high efficiency and convenient maintenance.
4. Applicable Scope Of Steel Strapping: 30mm - 60mm, Knot Wire Length: 40cm and above
Specifications：
Color: Orange
Material: Plastic + Metal
Voltage: 12V
Battery: 12V Lithium Ion Batteries
Battery Capacity: 13200 Mah
Battery Charging Time: 1.5 hours full filling
Tying Wire Diameter: 0.8mm
Tying Wire Length: more than 110 m
Applicable Scope Of Steel Strapping: 30mm - 60mm
Knot Wire Length: 40cm and above
Knot Number Per Charge: 3000 times
Knot The Required Time: 0.8 seconds at a time
Cable Length: 95cm / 37.40''(appr.)
Box Size: (L)X(W)X(H) 42X30X10cm / 16.54''X11.81''X3.94''(appr.)
Machine Size: 290 mm * 65 mm * 195 mm / 11.42''x2.56''x7.68''(appr.)
Operation Instructions
1. The rebar tirer's jaws are stuck to the intersection of the steel bars, and the steel bars are hooked at 45 degree angles. Note: There can be no barrier between the mouth of the jaws and the wire.
2. Press the start switch, the rebar tirer machine carries on the work (spins, hinges tightly, cuts off) Note: Press one button at a time, do not probe the jaws at work.
3. When automatic completion, the jaw from the steel bar intersection and then pull back, complete the process and prepare for the next binding.
4. When the binding process is not completed, do not unplug the machine in advance, otherwise it will cause the bundling of the goods tied skidding.
Operating Skills
1. In use, the left tilt 45 degrees after banding, the next time the banding into a right tilt 45 degrees banding, left and right alternately banding.
2. When the machine is about to tighten, the machine will appear slightly shaking, while holding the hand of the machine not too tight, you can relax properly.
Package included:
1X Tying Machine
1X Pliers
1X Charger
1X Storage Box
2X Lithium Ion Batteries
2X Tying Wire (0.8 mm x 110 m/roll)
