3M PPS Series 2.0 Adapter provides four points of connection from lid-to-gun and converts typical spray guns into ones that work with the 3M PPS Series 2.0 Spray Cup System. Specifically designed adapters allow painters to use PPS with virtually any spray gun model. To use this adapter, remove the existing spray gun cup. Then simply thread the correct PPS Adapter into the spray gun.Designed for 3M™ PPS™ Series 2.0 The redesigned 3M™ PPS™ Series 2.0 Adapter converts leading commercial spray guns into ones that can use the 3M™ PPS™ Series 2.0 Spray Cup System. This design provides four points of connection from lid-to-gun, offering improved stability and confidence during fast-paced, high-volume spraying. 3M™ PPS™ Series 2.0 is the next generation of the 3M™ PPS™ paint preparation system. The 3M™ PPS™ system features disposable lids, liners and hard plastic cups in 5 sizes: 3oz (90mL), 6.8oz (200mL), 13.5oz (400mL), 22oz (650mL) and 28oz (850mL). A choice of sizes offers maximum efficiency for every job, and helps lower your cost per use. Next Generation of the 3M™ PPS™ Paint Preparation System The 3M™ PPS™ Series 2.0 Spray Cup System is our latest, best-performing disposable spray cup system. The system has been redesigned from the connection to the cup, and has been improved in six ways offering a complete disposable spray cup solution for mixing/measuring, filtering, spraying and for temporary sealing and protection of sprayable coatings. Cleanest Disposable Cup System Every PPS™ Series 2.0 lid features a quarter-turn lid locking system to help reduce paint build-up and possible contamination. Additionally, each lid and liner kit contains a new hard cup which also features universal mixing ratios built into the cup, eliminating the need for separate inserts and helping ensure the most accurate mix possible. Reduce Material Waste by Mixing in the Cup 3M™ PPS™ Series 2.0 makes it even easier to mix directly in the cup. If you’re mixing on a scale, use the “max fill” notation on each cup to fit the maximum amount. Cups include a clear access window to help you see how much material is left while spraying. The window also allows you to hold the liner for easier, cleaner lid removal. This is especially useful during refills or tinting. Improved Fluid Flow for More Consistent Paint Application Our 3M™ PPS™ Series 2.0 Lids feature a domed geometry that allows up to 3 oz (90mL) of material below the filter during on-demand spraying. This reduces sputter and other inconsistencies in spray performance. Lids also feature a wider spout for improved fluid flow. A built-in full-diameter filter delivers the highest quality filtration – no assembly needed. More Confidence in the Connection to Your Gun A new adapter design provides a four-point connection and a wider 360° platform to ensure a stable, reliable lid-to-spray-gun connection. Larger sealing plugs do more than just seal. For instance, you can turn the cup upside down and use the new sealing plug as a base for temporary sealing and protecting, helping keep the built-in filter wet and reducing the need for replacement lids. A System for Both Solvent-Based and Waterborne Products Every lid features a built-in full diameter filter available in 200 micron or 125 micron mesh. Be sure to consult the paint or coatings manufacturer for the recommended filter mesh size. Use the Right Size Cup for Every Repair Our PPS™ 2.0 Spray Cup System is available in 5 sizes: 3 oz (90mL), 6.8 oz (200mL), 13.5 oz (400mL), 22 oz (650mL) and 28 oz (850mL). Using the right size cup for every repair not only reduces your cost per lid and liner, it can reduce the likelihood of overmixing
