Sullivan Products brand pair of heat treated steel control horns for heavy-duty
applications, like split elevators or pull-pull systems.
This Package
YOU WILL RECEIVE:
(2) 1-1/8 control horns - These have a L shaped cross-section and have
4 holes for mounting the clevis at the top of the horn.
(4) control horn mounting screws - These are 2-56 x 3/4 screws. They use
a flat head screwdriver to tighten/loosen.
(4) Plastic washers
(2) Control horn mounting plates - These are made of nylon.
(2) Nylon Clevis points - This piece mounts to the control horn. They have
a hole in the top where the clevis pin goes through. They secure to
the control horn by using a small piece of 1/32 music wire (or a paper
clip, neither are included)
(2) Nylon washers - These secure the clevis point to the control horn
A small piece of 1/32 music wire or a paper clip - used to secure the clevis
points to the control horn. JBN 6.16.94 *8)
