SKS Natural Red-Tip Yorker Caps with .030 Orifice Hole 12, Neck diameter 24mm, thread type 410

SKS natural LDPE Yorker spout caps have a .030 hole with a removable red tip. The caps are designed to aid in the dispensing of the container's contents through a hole at the end of the cone-shaped cap. These dispensing caps are great for condiments, glues, paints, and modeling and craft activities How to Measure a Neck Finish: To find a cap's diameter, measure from one side of the inner wall to the opposite side. Calculate a bottle's neck finish by measuring the diameter of the outermost threads. Then see how many times the threads pass one another to determine the finish. Ex. 24 mm with 1.5 thread turns = 24/410 neck finish. Note about cap and neck finishes: A container's neck finish holds the cap, stopper, or closure with protruding threads. A container and its corresponding cap must have matching finishes. For example, a 24/400 bottle will only accept a 24/400 closure. Screw thread or continuous thread closure sizes are expressed with two numbers separated by a hypen or slash. The first number refers to the millimeter diameter measured across the inside of the cap's opening or the outside of the bottle's threads. The second number refers to the thread style, "GPI" or "SPI" finish. The Glass Packaging Institute GPI and Society of the Plastics Industry SPI are responsible for establishing uniform standardsfor glass and plastic container neck finishes.The closure industry does not necessarily adhere to the same standards,so it is often best practice to purchase containers and capsfrom the same manufacturer when possible.