SHZOND Power Feed X-Axis 150lbs Torque,Power Feed Milling Machine 0-200PRM, Power Table Feed Mill

Power Table Feed X-Axis 150 LBS Torque Power Feed 200 RPM Adjustable Rotate Speed for Bridgeport and Similar Vertical Milling Machine

The power table feed kit is for bridgeport and similar knee type milling machines. These will fit almost any vertical knee type mill out there with the 5/8" shaft end, Including but not limited to Bridgeport,Precision Matthews, Grizzly, Enco, Jet, Sharp, Acer, Webb, GMC, Kent, Clark, Supermax, Enco, Turn Pro, Acra, Birmingham, Accu, First...etc.

Item Parameter

Power Table Feed Voltage: 110V, 60Hz,90W

Type: X-axis

Rotate speed: 0-200 RPM

Torque: 150 LBS

Features

Small volume and easy installation

Excellent speed control in the entire range

Power table feed won't vibrate or strain in low speed

Direction control knob for easy and rapid operation

Safety feature to protect transmission gear and electronic components

Maintenance

1. Gear cover must be open every 6 month to check whether lubrication for spiral gear is sufficient. Graphite type lubrication is suggested rather than silicon type.

2. Carbon brush cap should be open every 6 month to check if the brush has wore out. Brush should be replace immediately if its length is under 0.2inch (front and back brush should be replaced together).

Package Content

AS-250-150 X-Axis power feed for milling machine x 1

Set of necessary accessories x 1

Product manual x 1