Skin Decal Wrap Compatible With Ozark Trail Water Bottle 64 oz Southwest Stripes

Don't waste your money! This product is terrible. When it arrived, there were no application instructions included. Fine, I can find a video on YouTube myself. I watched a video of someone installing this brand of wrap on a tumbler. The first problem I encountered was that the body of the wrap was much too tall. When I aligned it with the bottom ridge of the water bottle, it was 7/8 inch too tall, meaning it would roll up over the top ridge and mash around the angled bend of the neck. It can not angle that way and stay on. That meant I had to peel off the vinyl and trim it so that it wouldn't roll up onto the angled neck. The next problem was that the wrap was too long/wide. The body of the tumbler wrap in the video was two pieces, where this is version is a single piece. Both versions make it difficult to line up seams, especially if you're a perfectionist like me. As I began wrapping it around the body again, I realized there was an overlap of 2 3/8 inches! I could have chosen to overlap the vinyl and leave it with two seams, but that looked ridiculous. I had to peel it off a second time and trim it down so the edges would meet at a single seem. This was no easy task, but I finally had the body wrapped, bubbles pressed out, and seams lined up. Then I moved onto the bottom ribbon that fits just under the seam of the water bottle. This piece was also much too long/wide. I had to trim it as well, lest I have the double seam/overlap dilemma again. Finally I moved on to the neck piece. This piece was the only piece that fit properly. I was excited to not need to trim again, but my excitement quickly faded when I found that if I lined up the pattern, the seam would be in a completely different place as the other two seams I'd created when I trimmed. I peeled that piece off, lined up the seams, and called it done. I'm very disappointed with the results.