Martingale Dog Collar by Lupine 3/4" Wide El Paso Design adjusts 14" to 20"

Martingale collars help prevent a dog from backing out of its collar. When there is tension on the leash, the martingale will reduce the size of the collar by a limited amount, preventing the collar from pulling off over the head (when the collar is properly adjusted). When the leash is slack, the collar relaxes to a looser fit as determined by the adjusted size of the collar. The Martingale Combo collar has a second D-ring which is sewn into the collar. It does not change the size of the collar as the martingale does. Attach the leash to it if the limited-slip action is not wanted or use to attach ID. Important Safety Information: Never leave this type of collar on your dog when itÕs playing with another dog or when unattended. There is a risk of entanglement and injury. This collar should always be removed when the dog is unattended. To determine collar size, measure snugly around the middle of the neck, then add an extra 5-percent for a comfortable fit. Also measure around the headÕs widest point, from under the jaw, over the top of the skull and back down to the start point. Be sure that the collar is large enough to go on over the head. There are two adjustable size ranges: 10-14 inches or 14-20 inches. 3/4-inch wide martingale collars are suitable for small to medium-large dogs. Lupine products are proudly built in Conway, New Hampshire and Guaranteed (Even if Chewed). They are not chew-proof (no fabric is!) but if they get chewed, Lupine will replace them. Search on ÔLupine GuaranteeÕ to see how EZ it is. Lupine Originals are made from woven nylon in an array of colorful designs. The pattern is woven into the webbing, rather than printed or sewn on. Made with strong bar-tack stitching, welded steel hardware, and ends are turned under and stitched to protect fur and skin. Matching padded handle leashes, regular collars, and harnesses are available. Lupine products are not intended for tie-out.