INTBUYING Salt Water Spray Chamber Machine for ASTM b117 Corrosive Fog Test

Please note that there are two color control panels are shipped randomly.
Description:
Equipment:
All equipment  needed in the test: Spray nozzle, salt water barrel, test piece support,  spray liquid collection container, test chamber, salt water, supply  tank, pressure tank, supply equipment and exhaust equipment required for  compressed air, the device is shown in Fig, and test as followed.
ü Blunt  material is required, it is required that the material itself cannot be  corroded, and it can not affect the corrosion test.
ü The  fog nozzle cannot spray the test liquid directly to the sample ,  the  solution at the top of the spraying chamber cannot drop on the test  piece.
ü The  test liquid dropped from test piece cannot flow back to the salt bucket  again for the test.
ü The  solution should not contain grease and dust, so you have to prepare an  air cleaner.
ü Spray  liquid should be collected at least 16 hours,  an average per hour can  be collected 2ml to 1ml solution. Use the final average to represent the  amount of spray.
ü The  concentration of the Sodium Chloride Solution should be maintained  at 40~60g/L.
ü The  temperature of the pressure barrel should be kept in 47+1 degree,   temperature of the brine barrel should be kept in 35+1 degree.

Sample placement:
If you need to test many pieces,  make sure that every major surface can be detected by salt fog at the  same time.
Permutation of samples, the spray  should be free to drop on all the test pieces, preventing the situation  of blocking the spray.
 Each sample cannot be in contact  with each other.
 Salt spray can’t drop from one test  piece to another one.
 Sample identification mark should be  marked on the bottom of the test piece.

Spray method:
Voltage: 110V
Adopting bernoute principle to absorb brine and then atomize, the degree of atomization is even, no blocking phenomenon of crystallization, can ensure the standard of continuous test.
Nozzles: made of special glass nozzles, the size of the spray can be adjusted.
Adopt the direct heating method, the heating speed is fast to reduce the standby time, when the temperature reaches ON. OFF switching, accurate temperature, less power consumption.(heating tube is made of high corrosion resistance heating system: titanium tube).

Meet the standard:
GB/T 2423. 17-1993：Salt spray test
GB/T 2423. 18-2000：Salt spray test
GB/T 10125-1997：Salt spray test
IEC68-2-52 1996：Salt spray test
ASTM. B117-97：Salt spray test
GB. 10587-89：Salt spray test
IEC68-2-11：Salt spray test
JIS H8502：Salt spray test
CNS. 4158：Salt spray test
CNS. 4159 CASS：Accelerate the spray test of cupric acetate
GB/T 12967.3-91 CASS：Accelerate the spray test of cupric acetate
GB/T 1771-2007：Neutral salt spray performance test of paints and varnishes
Item  included(239165):
1*  Salt Spray Testing Chamber 110V