110V Electric Steel Roller Thermal Laminator With Toothing Cutter Hot Cold Roll Laminator

Introduction:
You can use the steel roll laminator for thermal laminating and cold laminating operation. The steel roller thermal laminator is designed for high-quality clear lamination of your prints, presentations, menus, documents, book covers, photos and other visual aids. It can do single-sided or dual-sided laminating with 0-8mm thick films. The high-quality hard chromium plating rollers can evenly distribute the heat so that high-quality lamination can be ensured. It can be operated automatically or controlled through the foot control switch. It is an excellent laminating machine for print shops, graphics studio and professional offices.

Product Parameters:
Heating Method: Steel roller internal heating
Working Speed: Steplessly Adjustable 3-16ft(1-5M) per minute
Maximum Laminating Width: 14.17" (360mm)
Maximum Laminating Thickness: 0-0.31" (8mm)
Laminating Type: single or dual sides
Power Supply: 110 V/60Hz (One side 1.1KW，two-sided 2.2KW)
Laminating Temperature: 60-130 DEG C
Machine temperature: 0-160 DEG C
Operation Mode: Automatic or foot switch control
Warm Up Time: About 1 minutes
Machine Size: 24.02''x20.47''x24.02'' (61x52x61cm)
Net Weight: 97lb (44kg)

Notes
1. Close the protective cover during operation. Do not touch the heating rollers to avoid scalds and other accidents.
2. Do not touch the running parts during operation. Do not put the hands into the machine.
3. Be careful—the cutter blade is shape.

Operation Method
1. Unpack the package, ensure that all the accessories are intact, and assemble all the accessories on the main machine. Install the film roll and the material to be laminated in place.
2. Connect the machine to the 110V power supply firmly and stably, turn on the power switch, set the temperature through the temperature controller, select the single side laminating or double side laminating mode, select the forward or reverse rotation, adjust the speed, and select the automatic or foot pedal control mode.
3. After the temperature reaches the set value, start laminating.
4. If the film roll is slightly wider than the material to be laminated, use the toothing cutter to remove the unnecessary edge to meet the accurate laminating requirement.
5. After completing the laminating operation, turn off the power switch, press the handle on the side wall to lift the laminating roller, and clean the laminating machine thoroughly.

Item Number(122140): 1 x 110V Steel Roller Thermal Laminator With Toothing Cutter and Accessories