Square Rail Saw Table Dust-Free Saw Machine Manual Wood Cutting 220V

Introduction:
The foldable dust-free saw has the characteristics of compact structure, folding and stretching, and easy to carry. Aluminum alloy flip plate, oblique cutting 45 degrees, no adjustment saw blade can be fine-tuned, environmental dust and other advantages.
Operation Method:
Equipment debugging: Saw blade height adjustment: Ensure that the saw blade is about 5mm higher than the wood cutting surface. Ideally, two saw teeth should be visible. If it is too high, it may cause danger; if it is too low, the cutting surface may be charred or uneven. Backrest calibration: Use a right-angle square to measure the perpendicularity between the backrest and the saw blade to ensure that the cutting reference surface is straight and to prevent the wood from shifting or bouncing back.
Cutting implementation: Feeding posture: Push the wood forward with the thumb of the right hand and press down with the four fingers to maintain stability. The body should be on the left side of the saw blade to avoid rebound injury. When cutting long pieces of wood, auxiliary support or collaborative operation by multiple people is required. Feeding control: For short wood materials (width < 15cm), use a push rod for assistance. Manual pushing is strictly prohibited. Narrow wood (width less than 5cm) must use safety push blocks.
Note:
Check whether all components of the woodworking table saw machine are in good condition and whether the saw blades are installed firmly.
Operators must wear labor protection equipment properly, such as safety helmets, work clothes, protective glasses, protective gloves, etc.
Before operation, ensure that the saw blade rotates in the correct direction to prevent injury caused by operational errors.
During operation, it is strictly forbidden to insert hands or body parts into the rotating area of the saw blade.
When sawing the wood, keep the saw blade in smooth contact with the wood and avoid excessive force.
During operation, if any abnormality is found in the saw blade or the wood gets stuck, the machine should be stopped immediately for handling.
During operation, the Angle or height of the saw blade must not be adjusted without authorization. The machine should be stopped first and then operated by experienced technicians.

Parameters:
Saw Bench Parameters:
Saw Table Extension: 27.5"(700MM)
Folding Size: 39.3*23.6*12.5"(1000×600×320MM)
Square Rail Size: 1.5/2.3"(40/60MM)
Length: 47.2-86.6"(1200-2200MM)
Push Table Stroke: 59"(1500MM)
Multifunctional Flip Board: Large Gong Machine, Small Gong Machine, Curve Saw.
Saw Parameters:
Saw Core Size: 19.6*11.8*13.7"(500×300×350MM)
Saw Blade Size: 8"+4"(20+10CM)
Subsaw Power: 1.8KW
Female Saw Power: 2.6KW
Suction Power: 1.2KW

Items Included: 033504-EnzY
Wood Cutting Machine Saw Table 220V