8MM Animal Feed Pellet Mill Machine with 4 Head Rollers Animal Food Maker Feed Granulator Machine 220V

Introduction:
Feed granulator is widely used in large, medium and small aquaculture, grain feed processing plants, livestock farms, poultry farms, individual farmers and small and medium-sized farms, farmers or large, medium and small feed processing plants. This machine can be used alone, and customers who need it can also match it with a straw cutter for better results. Note: 1. Before using the machine, it is necessary to adjust the screw of the pressure roller to the appropriate position. The pressure roller and the pressure plate should be closely combined, and the four adjusting screws should be on the same horizontal plane. 2. Please refuel the fuel tank before using the machine. The machine should not idle for more than 2 minutes. 3.Double-check the belt and the screws before operation. 4.Clean up the rest after use to prevent damage to the machine. 5.If the pressure roller cannot rotate normally, please tighten the screws that control the pressure roller first, and then try to power it on. If it still does not work, you can appropriately loosen the screws next to the pressure roller and then tighten them slightly again (without special tightening) Product parameter: Pressure plate: 8MM Output/h Maximum output: 200KG (ideal state) Power: 4.5KW Voltage: 220V Single-phase electricity Product body material: Cast iron Standard pressure roller: Four head press roller Product size: 39.2*14.56*33.8in(99.5*37*86cm) The operation steps for disassembling and installing the grinding disc are consistent for double head pressure rollers, three head pressure rollers, and four head pressure rollers. The webpage only uses the double head pressure roller model as an example of operation. Precautions: 1.During granulation, it is strictly forbidden for the pressure roller to contact with the template to run idly, and the continuous feeding can not be interrupted.At the same time, the pressure roller shaft nut is locked to avoid loosening and damaging the spindle keyway. 2.Always check the tightness of the screws in each part of the machine. If there is oil leakage inthe gearbox, replace the oil seals in time, and check whether the bearings in the machine head are short of oil. 3.Before turning on the machine, it is necessary to add less material before turning on the machine. When shutting down, leave a small amount of feed in the machine to prevent the pressroller of the machine from contacting the template from idling. 4.If the machine is stuck in operation, stop it immediately, press the pressure roller until the bolt is flat,and then restart the machine. 5.Each time the work is completed, the adjusting pressure roller bolts must be loosened. 6.Check the elasticity of the belt, and the bearing frequently. Add oil in time when it needs to. Note: We suggest that high-power machines should be directly connected to the main power supply, as the voltage reaching the machine is stable. If the voltage is unstable and the current exceeds the rated current of the motor, it is easy to burn out the starting capacitor. It is recommended to directly connect to the power supply as much as possible. If the machine is not connected to the power supply, different situations may occur, and the wires are not durable. The wires will gradually burn out over time. Our machine is not equipped with a plug. If you do not know how to operate the wiring video, you can contact our customer service and we will provide you with the wiring video. (If there are occasional situations with plugs, it is also recommended that you remove the plugs when wiring) Item Number: 1*Chicken Feed Pellet Mill Machine 220V (239254)