One Way Privacy Film See Out but Not In,Window Tint for Home,Mirror Vinyl Roll Heat Control Anti UV Static Cling Sliding Door Coverings No Glue Garage Solar Paper(Sliver,23.3"×157.5")

TNYXORIX's One Way Daytime Privacy Window Film

❗Note:When the inside light is stronger than outside, such as the light on during the night, the mirror effect will be reversed and the inside can be seen from the outside. ❗ ❗❗Remember to draw curtains during the night ❗❗ ❗

✔️The color of BLACK has the best privacy.

Thickness: 0.15mm

UV blocking rate: 90%

Infrared blocking rate: 82%

Light transmittance: 10%

✔️The color of SLIVER that makes your room look the brightest without interfering with plant growth.

Thickness: 0.15mm

UV blocking rate: 80%

Infrared blocking rate: 80%

Light transmittance: 30%

✅DAYTIME ONE-WAY PRIVACY:One way window film provides great intended privacy during daytime,block unwanted vision and viewers.

✅STATIC CLING No ADHESIVES:The window tint are Glue free,no chemical release,easy apply,removable and no residue when remove

✅UV BLOCKING PROTECTION:Window reflective film can blocks out 97% of UV rays,reduces fading & aging of interior furnishings

✅DAYTIME & NIGHTIME EFFECT:When the light on night,outside will see inside.Remember to draw curtain during night

✅ANTI GLARE:10% of VLT can blockout most solar light but allow natural light in & without impact your plant grow

✅PACKAGE INCLUDED: 1 x KESPEN Mirror Window Film Roll; 1 X installation instructions.

★【Installation Steps】★

●1.Thoroughly clean your glass window with a lot of water.

●2.Measure your window size.

●3.Cut the film size 1 inch longer and wider to you window size to a good adjustment. 

●4.Spray a lot of soap water or detergent water to your window and the stick side of the privacy film.(6-9 drops of detergent in 500ml of water)

●5.Peel off the transparent film.

●6.Paste the wet side of the film onto the wet glass.

●7.Spray a lot of detergent water on the surface of the applied window film and then scrape the window film with a plastic scraper.(❗Tips:Use a  plastic spatula to scrape the film from the center to the edges, from top to bottom, this will allow excess water to drain out and the window film will be flat and bubble-free)

●8.Cut off the excess window film with a sharp utility knife.

●9.Wipe out surface water with a lint-free towel.

❗Useful Tips:

▲1.Peel off the transparent protective film before install.

▲2.Make sure the glass is completely clean and spray enough soapy water on the window & film.

▲3.If still have bubbles,just peel off the film,spray water on the glass & window film,then scrape again,the air bubbles easy to be removed

▲4.After finishing, please don't clean or move it for about 24 hours of sunshine time, when the sun dries it will be very firm