3M Headlight Lens Restoration System

I bought this to use on my daughters car that I had just bought that had one new and one original head lamp after watching a guy on you tube demonstrate it, and he was doing it for a living out of Florida. It took me about 1/2 hour to to follow all the steps and get the head light looking like new. I think the secret to this product over others is that you use a sanding disk that actually removes the top layer of plastic and then you seal it with this compound. And it gives you enough disks to probably do 4 to 6 lights. I just used 1 disk of each sand paper provided for this one light. I've included photos showing the before and after. The one thing I would say however is don't forget some trim tape to put around the light, it's the only thing that's not included (well you need a drill too LOL) and you'll need it to put around your light so you won't damage your paint in case when using the sanding disk you bump the edge of the paint.

Expend like 1 hour each side, sanding by hand(hard parts) and drill (to smooth), really impressive results, with lights on u can see all dry plastic, micro cracks,etc, but for a car face lift for just $16, completely worth it. Be sure to sand till all 'shine' parts completely gone before goes to next step to improve results, u need sand and sand till headlight get SOLID WHITE, last 2 steps make it clear again, and then u ll say wooowwwww.