Describe:
This OLED display module is small, measuring only 0.96 inches diagonally, and it consists of 128 x 64 individual yellow and blue OLED pixels, each of which is turned on or off by a controller chip.
It works without a backlight, i.e. in a dark environment, the OLED display is higher than the LCD display. You'll love the sharpness of the thumbnails.
The driver chip of this OLED is SSD1306, which is compatible with IIC communication. So this module can be controlled by I2C.
That is, in addition to VCC and GND, if 4-wire I2C mode is used, 2 wires are required.
There is also a simple switched capacitor charge pump that converts 5V to low voltage drive for OLEDs, making this module the easiest way to integrate OLEDs into your projects.
Size: 0.96 inches
High resolution: 128*64
Large viewing angle: 160°
Support many platforms: Arduino, 51 series MSP430 series, STM32/2. CSR chip, etc.
Ultra low power consumption; 0.04W during normal operation
Wide voltage support: 3.3V5V DC
Operating temperature: - 30°C 80°C
Driver chip; SSD1306
Communication method: IIC, only 2 I/0 ports are needed
No font library: use modulo software to take characters
Backlight: OLED self-illumination, no need for backlight
Package includes
1*Display module
