Features:
Red to E+
Black to E-
Green to A+
White to A-
Operating temperature range: -20 degrees ~ +85 degrees
Operating supply voltage range: 2.6 ~ 5.5V
Current consumption (including on-chip analog power regulator): normal operation <.5mA power-down <1uA
Simultaneous 50 and 60Hz power supply rejection
Output data rate can be 10SPS or 80SPS
Simple digital control and serial interface - no programming required.
On-chip ignition reset
On-chip oscillator requires no external components, with optional external
On-chip power regulator for load cell and ADC analog power supply
Active low-noise on-chip PGA with selectable 3264 and 128 gains
Two selectable differential input channels
Adopts 24-bit A/D converter to provide accurate weight measurement results. The load cell converts the applied force into an electrical signal, applies a 5-10V drive voltage, and the force is directly output as a voltage change signal.
The electronic sensor contains 4 leads for easy use. The weighing sensor needs to be connected to the HX711 module, red to E+, black to E-, green to A+, and white to A-
The sensor is fixed at end through the screw hole, and the other end remains suspended. Apply gravity in the direction indicated by the label. Pay special attention not to press the white rubber part directly to avoid damaging the sensor.
Specifications:
Part name: weighing pressure sensor
Material:Aluminum Alloy
