Stained Glass Supplies Kit Left-Handed Running Pliers Built in Stained Glass Cutting Tool, Glass Cutter Oil with Glass Drill Bits, Glass Hole Saw Drill Holes in Glass Bottles and Drill Glass Bottles

THE AMAZING TILE AND GLASS CUTTER Is a manual Tile Cutter that allows you to cut straight, radius and wavy lines in tile and glass products such as ceramic tiles, glass, mirror and floor tiles. The reason the cutter works so well despite what people think is not down to the cutting wheel being very sharp, in actual fact the cutter is probably the dullest tool you will ever own, but it is probably the hardest, this super hardness of the cutter blade along with the optimized angle ground into the edge of the scoring wheel allows The Amazing Tile And Glass Cutter tool to cut a variety of thicknesses’ of materials such as wall tiles, Subway Tile, Floor Tile, Glass Tile, Most Porcelain Tiles, Mosaic Tile and even Quarry Tile pavers Up To 3/4" Thick if instructions are followed closely. The Secrets to using The Amazing Tile And Glass Cutter successfully are to follow the instructions carefully. Practice on a spare tile to work out the correct pressure, usually not enough pressure is applied to start but occasionally it can cut better with less pressure especially on glass. Cutting on the floor for example instead of on a solid table at waist height will prevent even pressure being applied along the score line. Not oiling the cutting wheel and checking the cutting wheel is turning freely prior to scoring will cause the cutting wheel to bind, drag and even lock up across the surface instead of evenly scoring the surface. Holding the Cutter by the plastic grips when scoring with your strongest hand means that you are only applying minimal pressure if any on the cutting wheel at the point where the scoring is happening. Whether Cutting Stained Glass, Plate Glass, Picture Framing Glass or Fused Glass the cutting wheel should be oiled every single score, the oil will run down onto the glass and will not only cool down the glass and give a cleaner cut this will also extend the life of the cutting wheel. When you score glass if you can wipe the oil off the surface and there is no score line visible – you need to increase the pressure – make sure you are holding close to the wheel and use the 2 handed method if needed especially if you do not have a lot of strength in your hands or are cutting a very hard material. Secret for cutting thin strips of glass: The gap between the aluminum breaker and the bottom side of the jaws that holds the cutting wheel can be made smaller simply by folding the breaker forward and twisting / pivoting it forward on the rivet, this can be stiff to start with when the tool is new, and it can be glued in this position if you only cut thin glass all the time. Glass sheets for crafts can be Cut From 1/16" To 3/8" Thick and upto 8ft long can be cut and even thicker Glass Can Be Cut Using Techniques Included In The Detailed Instructions. Available in Red Black and Pink and also left handed – See somebody cares.