Freud 1-5/8 in. Dia. x 1/2 in. x 2-3/4 in. L Carbide Rounding Over Router Bit

I tested this bit on my router table with both softwood (syp) and hardwood (hard maple). For the 1st run, I set the bit for just a round-over, but full height in order to stress test the cutting ability. I was surprised at how clean the cut came out. There was a little blow-out on the long-grain going against the grain, but that cleaned up nicely. I then did a deeper cut both over the initial round-over - and on a new edge. The bit cut right through leaving a beautiful, clean surface. The wood was easy to feed, very little resistance, even on the end-grain on the maple. The photos below are straight off the router - no sanding or other clean-up. I didn't expect to get these results in one pass, with no tear-out.

The four carbide cutters on this bad boy combined with a proper feed rate make for very clean cuts, even on end grain. Great product!