Sunex 9710M 3/8-Inch Drive Metric Crowfoot Flare Nut Wrench Set, Size-10 - Size 19, 10-Piece

[This review was collected as part of a promotion.] I like that this set is a no skip 10-19mm set covering most sizes that you run into working on cars. You can never guess when you'll need one of these so it's good to be prepared. Machining and finishing on the set is good, but the stamped numbers are in some cases strangely spaced and or inconsistent. I'm still glad though that they are stamped rather than just having etched / printed markings which can wear off over time. There are no recesses in the wrenches to hold onto the retention ball on your ratchet / extension but they were a tight enough fit that they stayed on my extension just fine.

[This review was collected as part of a promotion.] If you have to work on power steering units, old hose fittings, or compression fittings, this is your tool. The design is much better than the typical open end wrench-type design - it is compact and has more edges covered. This design fits over the close fittings on power steering pumps and does not spread when a lot of pressure is applied. Think of it as an oxygen sensor-type application for hoses and tubing. It just works better than any other crowsfoot design I've previously used. For open end wrench replacement duties I use a breaker bar for extra torque - the length helps - and the tool did not spread or mar the fitting. The right tool for tight quarters and especially power steering work