GCU-10 Generator Control Unit is an universal economical programmable genset controller. Equipped with high illuminating LED with universal graphical interface helps to notify the operator the generator status. Optional relay moduleGCU-11R (12V/24V) helps to simplify the wiring and connection process.
Features:
Microprocessor Based Design
Universal LED Graphic Interface, Displays Generator Status and Failures
Modular Design, Quick Installation
Programmable Engine & Generator Controls Adapts Easily To Any Type Generator Set.
Waterproof Front Panel With UV Protection
Provide IDLE control For Elec. Governors
Five Adjustable Time Delay Potentiometers
Five DIP Switches For Specification Setting
Specification:
DC Supply
9.0 to 36 VDC
Alternator Input Range
Voltage 5~300 VDC
Frequency 50~60 Hz
Fuel Solenoid Signal Output
5 Amp @ 12/24 VDC
Start Signal Output
5 Amp @ 12/24 VDC
Warm up Signal Output
5 Amp @ 12/24 VDC
Accessory " ON " Output
5 Amp @ 12/24 VDC
Idle Control Conductor Capacity
5 Amp @ 12/24 VDC
Power Consumption
Under 3 VA on Auto
Adjustable Timers
Engine Pre-Heat : 2~30 sec.
Starter Cranking Time : 1~15 sec.
Energize to STOP : 1~15 sec.
Engine Idle (Governor) : 0~300 sec.
Engine Cool-down : 0~300 sec.
Environment
Operation Temperature : -20~70 °C
Relative Humidity : Maximum 90%
Protection & Alarm Status Indicators
Start Failure
High Water Temperature
Low Oil Pressure
Overspeed
Underspeed
Emergency Stop
Extra Prog. Input
Low Battery Voltage
Panel Installation Cut-Out
66.0 x 66.0 ±0.5 mm
Dimensions
72.0 (L) x 72.0 (W) x 50.0 (H) mm
Weight
166 g ±2%
