Brake Strobe Module Taillight Flasher Controller 12V LED Rear Alert Safety Stop

1x - Brake Light Strobe Module - Taillight Flasher
Get their attention - Before they get you!

Worried about inattentive drivers behind you? Don't want to spend $40-$60 on a bunch of flash modes you'll never use? The solution: this tiny, pre-programmed Brake Light Strobe Module. Our flash controller is programmed so that each time you hit the brakes your lights will flash 5x fast, and then stay illuminated as long as you're holding the brake. Release the brake and hit it again to reactivate the strobe sequence. Works great with LED systems, but can also be used on lower wattage incandescent bulbs.

Stats:
Dimensions: See Picture(s) for Approx Measurements.
Color: Black
Housing: High Impact Plastic, Water Resistant
Wire Length: Approximately - 5 inches each wire
Wiring: 22 AWG, 3Wires In / 2 Wires Out
Rated Input Voltage: 12-24 Volt DC Systems
Rated Input Current: 0.8A to 1.2A
Rated Power: 10-15 Watts
Working Temperature: -40°F to 122°F (-40°C to 50°C)
Storage Temperature: -58°F to 176°F (-50°C to 80°C)

NOTE: Depending on your light system and set-up, you may need to wire more than one Module into your system (Example: Split Taillights with higher wattage incandescent bulbs that collectively exceed the rated power for one module). Do your electrical research for your application before purchasing.

Fitment Information: This is a universal product; therefore, has multiple make and model fitments and applications. This includes, but is not limited to: Sportbikes, Cruisers, Scooters, ATV, Quad, UTV, MX, Dirt Bike, Enduro, Dual Sport, Golf Carts, Trailers, Automobiles, and even Snowmobiles.

Install Notes: These are NOT direct replacement parts. Always test the module with lights before installation to ensure they work properly. Use a FULLY charged Battery or a running motorcycle to perform the test. Identify the positive and negative wires leading from your main wire harness to your Brake Lights. Attach our V. IN (-)(Black Wire) to the bikes Negative wire and connect our V. IN (+)(F) (Red & Blue together) to the Brake Light Positive (Not the Running Light) wire coming from your bike. Attach our OUT (+)(Red) & (-)(Black) wires to the Brake Light Positive (NOT Running Light) and Negative wires leading to your Brake Light. Test the light functions before putting everything back together. If you have to apply two modules, repeat the process for the other side. Reassemble, Ride and Enjoy!