Big Horn Band Saw Replacement Tire For 18 Inch Wheel

PRODUCT DESCRIPTION 
These premium quality bandsaw tires are made slightly smaller then wheel diameter to provide a tight fit. Tire may be trimmed to fit narrower wheels. 

Compatible with Machines: 

Powermatic 

PWBS-14 (1791216K) 1.5HP 1Ph 115/230V Bandsaw 
PWBS-14CS (1791216K) 1.5HP 1Ph 115/230V Bandsaw 
Jet 

JWBS-14DXPRO Delux Pro Band Saw 
JWBS-14CS (708115K) 14-inch Woodworking Band Saw 
JWBS-14OS (708113A) 14-inch Woodworking Band Saw 
Features: 

These tires do not dry out, therefore, they will not crack, peel or harden like rubber tires do 
They hold so tightly to the wheel you wont need to glue them down. Colored bright orange for easier inspection 
Specifications: 

Diameter: 18" 
Width: 1" 
Thick: 1/8" 
Steps to Install: 

Remove wheel from saw, This greatly eases installation of the tire. 
Take old tire off wheel by prying it off with a flat bladed screwdriver, being careful not to damage wheel. 
Wash and clean wheel thoroughly making sure that the face of the wheel where the new tire will fit is free of any bumps or pitch built-up that could cause a high spot on the tire when installed. 
Hook new tire in groove and use a wooden dowel to roll the tire onto the wheel. 
Roll dowel around wheel under tire a couple of complete turns to equalize tension on tire. 
Remove dowel being careful not to get fingers pinched when the tire snaps into groove. 
Install wheel back on saw in same location as before. 
Note: Always keep tires clean with Bandsaw Blade Cleaner. This will improves tire life and also help your blades to last longer.