Description:
Product name: 20 types of intelligent temperature control three-speed electric heating handle sets
Packing size: 12.1*3.6*16.1CM
Input voltage: DC12V
Product line length: 108CM (heating film to switch) 146CM (switch to electric door lock)
Working temperature: -30°C---+100°C
Product power: high-end 20W mid-range 15W low-end 10W
Connection method: red connect to the positive pole, black connect to the negative pole (the lamp does not turn on when the connection is reversed, only heating)
Operating instructions: power on: red light, blue light and green light each flash once and then go out
Standby: the red light flashes in the state of breathing, the temperature reaches the relative temperature and it will automatically turn into a blue light
Working status: indicator light is always on (high-end: red light is always on, mid-range: blue light is always on, low-end, green light is always on)
Click on the key: switch gears
Note: The positive and negative poles are connected reversely, the switch cannot be used, and the heating element directly heats up
Product advantages:
Kevlar material, heat up faster, heat more evenly, successfully tested for wear resistance
Built-in intelligent temperature control chip, three-speed adjustable temperature, intelligent temperature control is more convenient
10 seconds rapid heating, large heating area
The heating piece is fixed by Velcro, which is convenient and quick
IP67 waterproof level, even if the switch and handle cover are soaked in water, they can work normally. When the handle cover needs to be cleaned, only unplug the plug and wash with water, which is very convenient
Package Included:
1 x electric handle cover
1 x glue
5 x cable tie
1 x stainless steel bracket
pay attention:
Please select the appropriate gear according to the ambient temperature. Under low temperature conditions, when the temperature of the electric heating grip cover cannot be sensed in time due to the numbness of the hand, please use the low or medium gear first to prevent high temperature burns
This product is only suitable for motorcycles with 12V battery. Please read the installation diagram carefully before installation. Incorrect wiring will cause damage to the components.
This product can only be installed on the handlebars of motorcycles when it is powered on. You can use a battery to test whether the product is properly powered on before installation
It is strictly forbidden to energize and work when not riding (empty burn) to prevent overheating of the electric handle cover and damage to the original handlebar
It is recommended to connect the electric door lock wire to the wiring. Most models have black positive pole and green negative pole. For specific conditions, it is recommended to use a multimeter to measure
