Swing/Sliding Gate PCB 220v AC 433 Mhz NC Model For Double Motor Swing/Sliding Gate Motor Circuit Board

Swing/Sliding Gate PCB 220v AC 433 Mhz NC model for double motor Swing/Sliding gate motor Circuit board

The circuit board can be used for swing and Sliding double door

NOTE

1. The circuit board is NC mode. Please do not remove the black short wire from the terminal unless you connect the corresponding accessory to the terminal.

2. Please ensure that your limit switch is also NC mode, so that it can work with the circuit board.

Product parameters and introduction

1. Open code-work with all rolling code

2. 220v for swing door ,working time :max.2min

3. photocells and band security(12/24V output)

4. electric lock (12V)

5. Flashing Light (220V)

6. power regulation of motors

7. limit switchs (two)

8. slow stop;auto close;Inversion shut/ Strike closes

9. 255codes

The circuit board can control two motors. If there is only one door, just connect one motor

The remote control does not contain batteries ,Battery model (27A ,12V)

noteIf you need a remote control, please buy one from our store. Other remote controls may not match the receiving chip of the circuit board.

Link to waterproof coverwaterproof cover