Motor Genic STATOR PULSE PICKUP COIL for Polaris Worker Magnum Sportsman 335 400 500 95-04

Pick-up Pulsar / Pulsing Coil Fit For Polaris 3085360 3089254 3084974

FEATURES:
Brand new pickup/pulsar coil for you to repair your stator.
Direct replacement to your original unit.
Plug-and-play, direct fit, easy installation.
Often unavailable from the OEM manufacturer.
All products shipped are tested.

SPECIFICATIONS:
Condition: Aftermarket 100% Brand New
Quanity: 1PC
Type: Pick up pulsar coil

Dimensions:
Height: 25mm
Length: 18mm
Width: 22mm
Bracket center to center: 35mm

Other specifications:
Number of wires: 2

PART NUMBER(S):
3089254
3084974
3085360
3085561
3086238
3086821
3086860
3086984
3087168
31100-KA5-761
31120-KA3-742
31120-KA3-761
31120-KA4-741
31120-KA4-761
31120-KA5-741
32150-05D00
32160-27C00
32160-37E00

FITMENT:
Fits Polaris ATP 500 2004
Fits Polaris Big Boss 500 1998-1999
Fits Polaris Int'l Big Boss 500 1999-2002
Fits Polaris Magnum 425 2x4 1995-1998
Fits Polaris Magnum 425 4x4 1995-1998
Fits Polaris Magnum 425 6x6 1996-1997
Fits Polaris Magnum 500 4x4 2000-2001
Fits Polaris Magnum 500 EB 2000
Fits Polaris Magnum 500 HDS 2x4 2002
Fits Polaris Magnum 500 HDS 4x4 1999-2003
Fits Polaris Magnum 500 RMK 2002
Fits Polaris Scrambler 500 2x4 2001-2002
Fits Polaris Scrambler 500 4x4 1997-2003
Fits Polaris Sportsman 335 1999-2000
Fits Polaris Sportsman 400 2001-2003
Fits Polaris Sportsman 400 4x4 F/C Carb 2004
Fits Polaris Sportsman 500 4x4 1996-2004
Fits Polaris Sportsman 500 6x6 2001-2002
Fits Polaris Sportsman 500 HO 2001-2004
Fits Polaris Worker 335 1999
Fits Polaris Worker 500 1999/2001-2002
Fits Polaris Xpedition 425 2000-2002
Fits Polaris Xplorer 500 1997

Fits Suzuki RM125 1989-2001
Fits Suzuki RM250 1986-2001

Fits Honda CR125R 1984-1985
Fits Honda CR250R 1984-1985
Fits Honda CR500R 1984-1986

PACKAGE INCLUDED:
1x Pick up pulsar coil

NOTICE:
Not following these instructions may result in damaging the part or other components on your vehicle.
-By using a small soldering iron weld the wires to the ones on your OEM wiring harness.
-Insulate your solders with heat shrink.
-Before attempting to start your vehicle, adjusting the air gap is necessary for certain models.
-Rotate the fly wheel by hand so the raised node is lined up with the pick up /pulsar coil and adjust as close as possible, but no less than 0.010 in.
-If no spark or erratic spark, switch the wires at the plug.